Custom electronics enclosures

AT-010 · One piece

We confirm feasibility after reviewing the sample or drawing.

The enclosure houses the circuit board and provides defined locations for connectors and mounting points.

AT-029 · One piece

We confirm feasibility after reviewing the sample or drawing.

The housing supports the sensor while leaving its sensing face exposed where needed.

AT-030 · One piece

We confirm feasibility after reviewing the sample or drawing.

The case holds a controller and its connectors together at a defined mounting location on the machine.

AT-052 · One piece

We confirm feasibility after reviewing the sample or drawing.

The housing locates the industrial sensor and defines access to its connector and sensing face.

AT-053 · One piece

We confirm feasibility after reviewing the sample or drawing.

The enclosure brings the controller board, connectors and mounting points into a single assembly.

AT-072 · One piece

We confirm feasibility after reviewing the sample or drawing.

The enclosure houses the automation controller and organises access to its wiring.

AT-101 · One piece

We confirm feasibility after reviewing the sample or drawing.

The enclosure houses ground-support electronics while keeping connectors accessible.

AT-114 · One piece

We confirm feasibility after reviewing the sample or drawing.

The enclosure groups electronic modules and defines mounting points and cable entries.